Removing the Battery Pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
The POWER lamp will remain lit for a while even if the battery pack is removed and the power cord is
unplugged after charging the battery pack. This is normal.
If the POWER lamp does not light, disconnect the AC power cord. After about one minute, reconnect the
AC power cord again.
You cannot operate the camcorder using the AC power adaptor while charging the battery pack.
When a fully charged battery pack is installed, the CHARGE lamps will light once, then go out.
Inserting the Battery Pack
(1) Slide OPEN and open the battery cover.
(2) Insert the battery pack until it is hooked by the RELEASE knob.
(3) Close the cover.